photodontist

Lightwalker Hanging Hook

Designed and printed up some custom wire management. Because I hate running over my Lightwalker cords

(c) 2019 Vu Le, DDS, all rights reserved
Your purchase of $3 grants you a limited use license to print these hooks for your own professional use within your own practice. Please do not redistribute or resell this design or prints of it.

Printing instructions: Use the slicer of your choice.

Printer: Prusa i3 MK3 was used, but any well calibrated FDM printer will do. A gcode file is provided for users of the Prusa i3 MK3 or MK3s

Filament: PLA, PETG, ABS, ASA will all print just fine

Layer heights: 0.20 or 0.30mm recommended (0.30 will be stronger but coarser looking)
Infill: 20% or higher
Top layers: 1mm or 5 layers
Bottom layers: 0.8mm or 4 layers
Perimeters / Vertical shells: 2 layers minimum, 3 would be stronger
No supports needed
Use glue or a raft if you have adhesion problems with your first layer.

SLA/Resin printers: use a tough resin if possible. Standard dental model resins may be too brittle.

Super easy installation instructions posted here.